Unpacking - Braillo 400 S 3 Series User Manual

BRAILLO NORWAY AS
●
2.1

Unpacking

Unpacking and installation can be done by the user.
After unpacking the printer, the cover must be removed before lifting the printer. See chapter 2.2
"Removal of Cover".
Any kind of lifting of the printer must always be done from the baseboard at the bottom of the printer,
or from the steel frame, and should be done with extreme care.
Make sure that your Braillo printer has not been damaged in transport. Check if the packing is
damaged; If so, it is possible that the printer has also been damaged or scratched. If any damages are
found, please contact your distributor or Braillo Norway AS immediately.
Also check that the printer is accompanied with the following items:
1 Power cable for the printer
2 Data cables (serial and parallel)
1 Serial adapter (9-25 pin)
1 A small stack of paper
1 User's guide
1 Toolkit for service and maintenance
2 Paper shelfs with screws
1 Test and packing list
If any of these items are missing, please contact your distributor or Braillo Norway AS.
Important !
It is very important that the printer's specifi ed voltage value (220V, +/- 10%) corresponds with the
local mains power supply available.
If the plug on the mains power cable is to be replaced, note that the yellow/green wire is the grounding
(earthing) wire.
After the printer is unpacked, make sure that the transport box is kept for eventually later use.
B 400 Series 3
7