Cleaning The Motorblock; Troubleshooting - Gastroback DESIGN MIXER ADVANCED Operation Instructions Manual

Cleaning the motorblock

WARNING:
Do not place the appliance in an automatic dishwasher or pour boiling
water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on it
or place the motor on wet surfaces. Always wipe off spilled liquids immediately. Ensure that
no water can run into the louvre. When liquids are spilled on the motor housing, immedi-
ately unplug the appliance and dry the motor housing to avoid risk of electric shock or
fire. Do not attempt to operate the appliance, when liquids are on or in the motor housing.
1. Always turn the appliance off, wait for the motor to stop completely, and unplug the
appliance from the power outlet before you start cleaning the motorblock.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill
or drip water or any other liquids on the motor housing.
ATTENTION: Ensure not to damage the drive gear. Never poke with anything into the
motorblock. If necessary use a soft brush for cleaning. If any liquids run into the motorblock
clean and dry the motorblock very carefully.
3. Thoroughly dry the motor housing after each cleaning or leave it dry naturally where it is
out of reach of young children. Afterwards assemble the appliance.
Attendance: You do not need to oil the motor. Clean the units only as described in the
instructions.
WARNING:
Return the entire appliance (including all parts and accessories) to an
authorised service centre for examination and repair.
TROUBLE SHOOTING
The Design Mixer Advanced is reliable and robust and handling it with care it will oper-
ate properly. For the case that problems show up you can solve the problems on your own
using the trouble shooting guide.
WARNING:
Only use the appliance for the intended use. For attendance and repair
take the appliance to an authorised service centre.
Problem
Motor doesn't start or blade
doesn't rotate
The motor stucks or slows down
Solution
Check that the power plug is securely inserted into the power outlet and switched on.
Check that the blender jug and lid are securely locked into position. Check that the
POWER button and selected function or speed setting is illuminated.
Be sure to press only one speed or function button at a time.
Use a higher speed for processing. If necessary (because the blender jug is overloaded)
pour out part of the content of the blender jug. Chop hard ingredients such as nuts or
chocolate before putting them into the blender jug.
63