Cleaning The Blender Jug; Disassembling The Blender Jug And Removing Stubborn Residues - Gastroback DESIGN MIXER ADVANCED Operation Instructions Manual

Cleaning the blender jug

1. Empty the blender jug and rise it with warm water.
2. Replace the blender jug on the motorblock and ensure it is securely locked into position.
3. Fill the blender jug with warm soapy water. The waterlevel should be high enough to
cover the blade with water but not too high to avoid run over liquids. Close the lid and turn
on the motor on ›5‹. Let the motor run for a few seconds.
4. Turn the motor off, wait for the blade to stop moving and take the blender jug off the
motorblock.
5. Pull the power cord out of the power outlet.
6. Take the lid off the blender jug and pour out the water. Stubborn residues you can remove
using a nylon washing brush or sponge.
WARNING:
Pay attention not to cut yourself cleaning around the blade or cleaning
the blade.
IMPORTANT: The blender jug should be clean now. For the case that there are stub-
born residues on the blender jug or the blade, disassemble the blender jug and clean the
single unit (see ›Assembling and disassembling the appliance‹). Soak the units in warm
soapy water.
7. Clean the lid and the refill lid with soapy water.
8. Rinse the blender jug, the lid, and the refill lid with clear water and dry the units
thoroughly and carefully with a cloth or leave all parts dry naturally where they are out of
reach of young children.
Note: The blender jug is dishwasher safe.
Note: The lid, refill lid and blade assembly housing are not dishwasher safe. Ensure to
remove the blade assembly housing and take the lid off the blender jug before placing the
blender jug into the dishwasher.

Disassembling the blender jug and removing stubborn residues

WARNING:
The blade is very sharp! Do not touch the blade. To handle the blade,
always hold on to the blade assembly housing.
1. Take the blender jug off the motorblock and hold it over the sink. Remove the holder turning
it ¼ of a turn clockwise. Take the holder off the blender jug and remove the blade.
ATTENTION: The blender jug might be connected really tight to the holder. Do not use
force unscrewing it.
2. Rinse all units in warm soapy water. Soak stubborn residues for a few minutes and then
remove them using a nylon washing brush or sponge. Do not cut yourself. Beware not
to damage the sealing ring. If you can not get the sealing ring clean or if it is porous or dam-
aged you have to replace it. Contact your vendor for replacement units.
3. After cleaning rinse all parts with clear water and dry them carefully. You can also leave
all parts dry naturally where they are out of reach of young children. When the units are
dry assemble the blender jug for storage or usage.
62