Care And Cleaning - Gastroback DESIGN MIXER ADVANCED Operation Instructions Manual

the time you press the button down and which should be pressed in short intervals only.
One interval takes 1 second.
Note: The speed can be changed at any time during the blending process. Each time a new speed
is selected its button will illuminate and the previous speed button illumination will go out.
ATTENTION: If the motor slows down or stucks turn the appliance off imme-
diately to avoid overheating (see ›Trouble shooting‹).
5. Turn the appliance ´Off` when the operation is finished.
Note: Operate the blender only for the appropriate amount of time required – do not
over process.
To stop blending at any time, press the STOP button or the selected speed button. The
selected speedcontrol button and STOP button illumination will go out and the POWER
button starts flashing. The appliance is set into the operational mode.
Note: The POWER button can also be pressed, but this will also turn the appliance
off and all illuminations will go out.
IMPORTANT: The blender will automatically stop blending after 120 seconds (2 minutes)
and the function button and STOP button illumination will go out. The POWER button will
illuminate and flash. This is a safety feature.
6. As soon as the motor stops moving you can take the blender jug off the motorblock
holding on to the handle. Take off the lid to check the consistency of the food or to push
down the food from the sides of the blender jug. You can fill in more ingredients through
the refill aperture. Turn the refill lid anticlockwise and lift it. After adding the ingredients
close the refill aperture, place the blender jug on the motorblock and make sure it is
securely locked. Turn on the appliance. Process until the food has the favoured texture.
7. Turn the appliance off as soon as you are done with operating and take the blender
jug off the motorblock. You can pour out liquid foods.
IMPORTANT: Do not leave any food dry on the surfaces of the appliance. Always clean
the appliance right after use (see ›Care and Cleaning‹).

CARE AND CLEANING

WARNING:
To avoid injury to persons and damage, always turn the appliance off, wait
for the motor to stop completely and unplug the appliance, immediately after operation
and before assembling/disassembling or cleaning the appliance.
WARNING:
Ware oven gloves if processing hot food. Ensure not to get burned on
spilled over liquids or steam.
ATTENTION: Do not use abrasive cleaners, cleaning pads, corrosive chemicals (disin-
fectants, bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning, for this
could damage the surfaces. Always handle the entire appliance with care and without
violence.
61