Table of Contents
Advertisement
Q. How can I associate descriptive information with a point for the RTU granular traps?
A. The NetGuardian alarm point descriptions are individually defined using the Web Browser, TTY, or Edit216F
configuration interfaces.
Q. My SNMP traps aren't getting through. What should I try?
A. Try these three steps:
1. Make sure that the Trap Address (IP address of the SNMP manager) is defined. (If you changed the
Trap Address, make sure you saved the change to NVRAM and rebooted.)
2. Make sure all alarm points are configured to send SNMP traps.
3. Make sure the NetGuardian and the SNMP manager are both on the network. Use the NetGuardian's
ping command to ping the SNMP manager.
47
Advertisement
Table of Contents
Need help?
Do you have a question about the NetGuardian 216F and is the answer not in the manual?
Questions and answers