REMKO Smart Control Touch Operating Manual page 72

REMKO Smart-Control Touch
Warnings
ID Description
ID8107 Compressor status
Anti-freeze protection
ID8132
active
Lower application area
ID8139
(heating)
Upper application area
ID8140
(heating)
Lower application area
ID8141
(cooling)
Upper application area
ID8142
(cooling)
ID8223 SD card error (host)
ID8224 SD card error
ID8225 Dewpoint monitoring
Hygiene function:
ID8227
Setpoint not reached
72
Desig. Details
The active operating mode is safety mode because the
compressor is active without demand
The anti-freeze protection function is currently active -
check the room climate mode set
The temperature has currently dropped below the guaran-
teed application area of the external unit in heating mode
The guaranteed application area of the external unit in
heating mode is currently exceeded
The temperature has currently dropped below the guaran-
teed application area of the external unit in cooling mode
The guaranteed application area of the external unit in
cooling mode is currently exceeded
SD card error (host): The SD card is either not inserted
correctly or an error has occurred
SD card error (CP): The SD card is not inserted or an error
has occurred
Dew point monitoring was activated but no control panel
CP (with integrated humidity and temperature probe) was
assigned to the cooling cycle to calculate the dew point
The hygiene function was cancelled due to the maximum
runtime being reached before attaining the set temperature