REMKO Smart Control Touch Operating Manual page 71

ID Description
ID7248 Interface is not supported
Incorrect interface
ID7249
detected
ID7276 Restart required
Communications malfunc-
ID7277
tion
Communications malfunc-
ID7279
tion
Communications malfunc-
ID7280
tion
Communications malfunc-
ID7281
tion
ID7286 Coding error
Open contact -
ID7296 2nd mix. cycle return flow
temp.
Short circuit -
ID7297 2nd mix. cycle return flow
temp.
Open contact -
ID7298
3rd mix. cycle inlet temp.
Short circuit -
ID7299
3rd mix. cycle inlet temp.
Open contact -
ID7300 3rd mix. cycle return flow
temp.
Short circuit -
ID7301 3rd mix. cycle return flow
temp.
Open contact -
ID7328
2nd mix. cycle inlet temp.
Short circuit - 2nd mix.
ID7329
cycle inlet temp.
Desig. Details
The KNXnet/IP tunnelling protocol is not supported by the
KNX
detected KNX interface
The physical address of the detected KNXnet/IP interface
KNX is not consistent with the parameter settings of the SMT
controller
Due to the changed system (setting/coding resistor), the
controller has to be restarted - disconnect it from the power
supply for around 10 seconds
HP7 Communications malfunction - 7th Heat pump
HP8 Communications malfunction - 8th Heat pump
HP9 Communications malfunction - 9th Heat pump
HP10 Communications malfunction - 10th Heat pump
A unique unit identifier could not be assigned using the
Rc
coding resistor at the Rc terminal
S14 Open contact - 2nd mix. cycle return flow temp.
S14 Short circuit - 2nd mix. cycle return flow temp.
S15 Open contact - 3rd mix. cycle inlet temp.
S15 Short circuit - 3rd mix. cycle inlet temp.
S16 Open contact - 3rd mix. cycle return flow temp.
S16 Short circuit - 3rd mix. cycle return flow temp.
S13 Open contact - 2nd mix. cycle inlet temp.
S13 Short circuit - 2nd mix. cycle inlet temp.
71