Wlan Function - REMKO Smart Control Touch Operating Manual

4.4 WLAN function

Installation and setup of the WLAN function
System requirements
The following system requirements are necessary
to complete the WLAN function installation suc-
cessfully:
n REMKO Smart Control Touch controller with
software version 4.25 or higher
n JavaScript/HTML5-capable web browser
(version not more than two years old)
n Broadband internet connection of at least
10 mbit/s
n The WLAN router must support the WPA 2
encryption/security standard
Installation in house
The central controller for the REMKO heat pump
via a smart phone or other mobile devices can be
installed virtually anywhere in the building.
WLAN
1
Fig. 10: External access
1: Router (example)
The connection requires a router which is con-
nected directly to the control unit of the heat pump
via WLAN.
NOTICE!
The router must be set up by a specialist
The WLAN function is limited to the in-house
WLAN network of the operator only. Outside the
WLAN network of the in-house router, access to
the heat pump parameters is not possible.
WLAN
2
2: REMKO Smart-Control Touch
27