REMKO Smart Control Touch Operating Manual page 53

"Message" menu item
Manual mode (probes)
Parameter
Unmix. circuit medium flow rate
1st mixed circuit medium flow rate
2nd mixed circuit medium flow rate
3rd mixed circuit medium flow rate
Energy supplier external block
Parameter
ModBus
Heat pump operating mode
Heating/cooling enable
Enable hot water
Enable E-heater
Manual defrosting
"Settings" menu item
Commissioning
Information on the "Commissioning" menu item is described in the separate "Commissioning wizard" chapter
on the next pages.
"Settings" menu item
Chimney sweep
Level 2 menu item
Mode
Hot water valve
Running time
"Messages" menu item
This menu displays warnings, warning information and error messages.
If this "Messages" symbol should light up in red or yellow in the basic display, it is necessary to check which
fault, warning or note is displayed on the message level. In order to call up the message level, it is only nec-
essary to touch the symbol.
(continued) - Expert
(continued)
(continued) - Expert
(continued) - Expert
- Expert
Selection parameter
S21
Default value "Impulse 0 - 100 l/min"
S22
Default value "Impulse 0 - 100 l/min"
S23
Default value "Impulse 0 - 100 l/min"
S24
Default value "Impulse 0 - 100 l/min"
S40
Selection parameter
µPC
µPC
deactivated / HP1 / HP2 / HP3
µPC
deactivated / HP1 / HP2 / HP3
µPC
deactivated / HP1 / HP2 / HP3
µPC
deactivated / HP1 / HP2 / HP3
Level 3 menu item
Normal operation/test mode
Deactivated/activated
15 - 90 minutes
Probe value
Probe value
Probe value
Probe value
Auto / On / Off
Auto / On / Off
53