REMKO Smart Control Touch Operating Manual page 56

REMKO Smart-Control Touch
Setting the time
From here, you can set the current time. The controller has automatic summertime switching, which can also
be activated from the menu "Language/Time" (+1 CET).
When setting the time, first the hours are selected, and then the minutes.
Menu item
Time setting
Restore counter readings
When first installing the controller, this parameter is confirmed with "NO".
Confirm this parameter with "YES" if you have performed a software update and wish to restore the previous
counter readings.
Menu item
Restore counter readings
Load user settings
When first installing the controller this parameter is confirmed with "NO".
If a new software status is installed after the initial installation, it is possible to confirm this with "YES" and all
existing parameters will be accepted anew. This means a complete new installation is unnecessary.
Menu item
Load user settings
Activating the heat pump
The controller detects automatically that a heat pump has been connected. If necessary, activate the heat
pump.
Menu item
Activating the heat pump
Heat pump selection
Auxiliary heat generator
56
Parameter
Hours
Minutes
Parameter
YES
NO
Parameter
YES
NO
Parameter
Activated
Deactivated
1-10
Active/inactive
Factory setting
Current time entry
Factory setting
NO
Factory setting
NO
Factory setting
Activated
1
Inactive