Transceiver Application-Controlled Leds; Table 63: Transceiver Application-Controlled Leds - Motorola ASTRO 25 GTR 8000 Manual

MN003286A01-E
Chapter 10: GTR 8000 Base Radio Reference
10.1.1.3

Transceiver Application-Controlled LEDs

The application-controlled LEDs can be green, red, or amber depending on the conditions.

Table 63: Transceiver Application-Controlled LEDs

Condition
Booting Up*
Lamp Test
Receiver Inhibited
Receiver Active
RF Channel Interference
Monitor Before Data Transmit
Illegal Carrier
Control Channel (Operating)
Control Channel (Failsoft)
Service Mode
Transmitter Inhibited
Infrastructure Link Connected
(V.24, IP, and 4–wire/V.24)
Partial Infrastructure Link Es-
tablished (V.24 link established,
4–wire link not established)
Infrastructure Link Disconnect-
ed (V.24, IP, and 4–wire/V-24)
* During a normal boot up sequence, LEDs 1 through 4 blink from left to right and from right to left
continuously for several seconds.
266
LED 2
LED 1 Re- Control
ceive Sta- Channel
tus Status
Green Green
Amber Amber
Amber
(blinking)
Green
Red (blink-
ing)
Green
Red (blink-
ing)
Green
Green
(blinking)
LED 4 Infra-
LED 3 Tx/ structure Pay-
Service Sta- load Link Sta-
tus
Green Green
Amber Amber
Amber
Amber (blink-
ing)
Green
Amber
Green (blinking)
tus