Dash Mount Configuration; Base/Control Stations; Figure 1-3. Dash Mount Configuration; Figure 1-4. Remote Mount Configuration, With 110W Transceiver - Motorola XPR 4300 Installation Manual

1-2
1.2 Standard Configurations
1.2.1

Dash Mount Configuration

In the dash mounting version of the XPR 4300/4350/4500/4550, the control head is mounted on the
front of the transceiver housing. Electrical connection between the two takes place within the radio
via a flexible circuit board between the connectors on the front of the transceiver and at the back of
the control head.
For details on this configuration, see
NOTE:

Figure 1-4. Remote Mount Configuration, with 110W transceiver

For details on these configurations, see
1.3

Base/Control Stations

If mobile radio equipment is installed at a fixed location and operated as a control station or as a
fixed unit, the antenna installation must comply with the following requirements in order to ensure
optimal performance and compliance with the RF energy exposure limits in the standards and
guidelines listed in the 68P81095C99 manual:
• The antenna should be mounted outside the building on the roof or a tower if at all possible.
• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional compli-
ance actions such as site survey measurements, signage, and site access restrictions in order
to ensure that exposure limits are not exceeded.
March 23, 2006

Figure 1-3. Dash Mount Configuration

Section 2.2.1 on page
Section 2.2.2 on page
Introduction: Standard Configurations
2-5.
2-8.
6816812H01