Setting The Date And Time In Css - Motorola ASTRO 25 GTR 8000 Manual

CAUTION: It is crucial that a site software download is performed at the site to ensure
that all devices are on the same software version, VLAN, and active bank. Failure to
perform this step results in the replacement transceiver or expansion channel to have a
mismatch in software versions. If a mismatch in software versions occurs, the transceiver
may go into a configuration mode of operation with a reason of 'Invalid Software Version'.
See one of the following procedures:
• For GTR 8000 Base Radios with PSC 9600 Site Controller:
PSC 9600 Site Controllers on page
• For GTR 8000 Base Radios with GCP 8000 Site Controller:
Download With GCP 8000 Site Controllers on page
23 Disconnect the service computer/laptop from the transceivers DB-9 serial port.
24 Perform basic device configuration using the Ethernet port in CSS. See
Ethernet Port Link on page
a Set the current date and time. See
b Set up the local Password Configuration (optional). See
Configuration in CSS on page
NOTICE: An IP address must be configured to set up the local password. If the serial
port access is not available to configure the IP address, the transceiver may have the
account locked out or the backplane slot has passwords enabled. Connect to the
front-panel local Ethernet service port using a fixed IP address to perform the
password reset. See
25 Complete the configuration of the Information Assurance features using CSS, as follows:
a Change the SNMPv3 configuration and user credentials. See
Configuration and User Credentials in CSS on page
b Create, update, or delete an SNMPv3 user. See
CSS on page 146.
c Verify the SNMPv3 credentials. See
on page 146.
d Set the Software Download Manager (SWDL) transfer mode. See
Mode in CSS on page
e Configure Domain Name Services (DNS). See Chapter 7, "Configuring DNS with CSS" in the
Authentication Services manual.
f Configure for Secure SHell (SSH). See Chapter 4, "Configuring SSH for Devices in an RF
Site" in the Securing Protocols with SSH manual or see "Device Security Configuration –
Remote Access/Login Banner (Ethernet)" in the CSS Online Help.
NOTICE: Restore the Clear Protocols parameters.
g Enable RADIUS Authentication. See Chapter 7, "Configuring RADIUS Sources and
Parameters with CSS" in the Authentication Services manual.
h Enable Centralized Authentication. See Chapter 7, "Enabling/Disabling Centralized
Authentication with CSS" in the Authentication Services manual.
i Set the Local Cache Size for Centralized Authentication. See Chapter 7, "Setting the Local
Cache Size for Central Authentication in CSS" in the Authentication Services manual.
j Enable Centralized Event Logging (if required by your organization). See Chapter 6,
"Enabling/Disabling Centralized Event Logging on Devices with CSS" and Chapter 1, "Event
Logging Client Configuration" for proper hostnames in the Centralized Event Logging
manual.
Chapter 9: GTR 8000 Base Radio FRU Procedures
276.
140.
Setting the Date and Time in CSS on page
149.
Connecting Through an Ethernet Port Link on page
Performing an SNMPv3 Connection Verification in CSS
147.
Performing a Site Download With
Performing a Site Software
278.
Connecting Through an
Setting the Local Password
Changing SNMPv3
143.
Adding or Modifying an SNMPv3 User in
Setting the SWDL Transfer
MN003286A01-E
143.
140.
235