Chapter 5 Disassembly & Reassembly and
Replacement Procedures
General
The disassembly/reassembly procedure covers all radio models. Specific model information is
included in the procedure where relevant. Where nothing is indicated, the procedure will be valid for
all models.
!
C a u t i o n
Disassembly to Transceiver Board Level Low and Mid Power Models
Remove the Control Head
NOTE: Steps 1 and 2, Removal of the Retention Frame, are only valid for Models II and III, Low and
Mid Power Dash Mount version radios.
1. On Models II & III, Dash Mount only: Prior to removing the control head, remove the reten-
tion frame by inserting a small flat blade screwdriver in the cut outs provided.
2. On Models II & III, Dash Mount only: Slide the retention frame away from the control head
groove.
3. Insert a small blade screw driver or like instrument in the side groove at the interface between
the control head and the transceiver (see
from the transceiver press until the control head side releases, and then repeat the operation
on the opposite side.
DO NOT attempt to disassemble the radio without first
referring to the CMOS Precautions paragraph on page 2-2 in
the Maintenance section.
Control Head I
See Detail "A"
Depress Snap Here
Detail "A"
Figure 5-1. Removing the Control Head
Figure
5-1). While pulling the control head away
Transceiver