Table of Contents
Advertisement
6 - 8
Top Plastic Cover Removal
1.
Insert the dismantling tool in the middle of the terminal assembly side groove.
2.
Pull and maneuver the sides of the top plastic cover, until the cover is released from the
terminal chassis.
3.
Lift the top plastic cover from the chassis.
Transceiver Board Removal
1.
Remove the tamper label on the die cast cover.
2.
Remove seven screws from the diecast cover using a T20 TORX
cast cover.
Figure 6-3 Top Cover Removal
See Detail A
Figure 6-4 Tamper Label Removal
Dismantling
Tool
Detail A
™
driver, and remove the die
Maintenance
ZWG0130211-O
Advertisement
Table of Contents
