Introduction: Standard Configurations
1.2.2
Remote Mount Configuration
In the remote control version, the transceiver and the control head are mounted separately in the
vehicle. The O5 control head is mounted in a remote trunnion near the operator, and the O3 and O9
control heads are also mounted near the operator using an extension cable. The transceiver and
control head are mounted by means of a trunnion or other mounting hardware. If the transceiver is
located in a car trunk, be sure that secure mounting and sufficient cooling are provided. Do not cover
the transceiver with baggage, blankets, etc.
Figure 1-15. Remote Mount Configuration with Mid Power Transceiver and
NOTE: The keypad mic should only be plugged into the Modified Modular Plug (MMP) connector
located on the control head, in either dash mount or remote mount configuration.
Figure 1-16. Remote Mount Configuration with Mid Power Transceiver,
6878215A01
MMP
O5 Control Head
5 m (17 ft) Extension Cable
Transceiver Interface Board, and O3 Control Head
MMP
1-5