Setting Css Configuration Parameters For The Gtr 8000 Base Radio (Trunked Simulcast); Setting Rmc System Gain - Motorola ASTRO 25 GTR 8000 Manual

MN003286A01-E
Chapter 4: GTR 8000 Base Radio Configuration
Password Aging Time [days]
This field allows you to enter a value between 0 and 65535 for the maximum number of days a local
password is valid. After the Password Aging Time has elapsed, the password must be changed.
The default value is 0.
Change Interval Limit [days]
This field allows you to enter a value between 0 and 65535 for the number of days which must
elapse before a local password can be changed. The default value is 1.
4.4.6
Setting CSS Configuration Parameters for the GTR 8000 Base Radio
(Trunked Simulcast)
Prerequisites:
Before proceeding with this process, complete the initial configuration of the device in
Device Configuration on page
For configuration parameters on each field for a trunked simulcast GTR 8000 Base Radio, see "Multi-
Site or Simulcast Subsystem" in the CSS Online Help.
Process:
1 Connect to the base radio through an Ethernet port link and then read the configuration file from
the base radio. See
2 In the System tree, click System and complete the fields.
3 In the System tree, click Site and complete the fields.
4 In the System tree, click Channel and complete the fields.
5 In the System tree, click Subsite and complete the fields.
6 In the System tree, click Configuration and complete the fields on all four tabs.
NOTICE: As part of Remote Multicoupler (RMC) configuration, set the DIP switches on
the RMC/Low Noise Amplifier (LNA) modules. See
154.
7 In the System tree, click Network Services Configuration and complete the fields on the three
tabs.
NOTICE: For configuration details for DNS and RADIUS Services, see the Authentication
Services manual. For configuration details for SYSLOG Services, see the Centralized
Event Logging manual.
8 In the System tree, click Password Configuration and complete the fields.
NOTICE: Password Configuration is only required if you have passwords entered for
local accounts and sets the password complexity and controls. For details on password
complexity and controls, see "Password Configuration" in CSS Online Help.
9 In the System tree, click Enhanced Data Configuration to view the fields.
10 From the menu, select File → Save As to save the configuration data to a new archive file or
select File → Save to overwrite the existing archive file.
IMPORTANT: Save any configuration changes to a local or network drive so that if the
base radios transceiver module fails, you can load your settings to a replacement base
radio transceiver. If the configuration file is not saved to a local or network drive, repeat
the setup steps after replacing a transceiver module.
11 From the menu, select File → Write Configuration to Device to write the configuration data to
the base radio.
150
134.
Connecting Through an Ethernet Port Link on page
CSS Initial
140.
Setting RMC System Gain on page