Edid On The Dvi, Hdmi And Displayport Inputs; Using Hdmi/Dvi/Displayport Switchers With The Projector - Digital Projection INSIGHT 4K Laser Series Installation And Quick Start Manual

Digital Projection INSIGHT 4K Laser Series

EDID on the DVI, HDMI and DisplayPort inputs

If you are using a computer DVI card or another source that obeys the EDID protocol, the source will automatically configure itself to suit the
projector.
Otherwise please refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector
or the nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.

Using HDMI/DVI/DisplayPort switchers with the projector

When using an HDMI/DVI/DisplayPort source switcher with the projector, it is important to set the switcher so that it passes the projector
EDID through to the source devices. If this is not done, the projector may not be able to lock to the source or display the source correctly as
its video output timings may not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode.
See your switcher's manual for information on how to set this mode.
Additionally, sources which use HDCP encryption may not display properly when connected to the projector via a switcher. Refer to the
switcher's manual for more information.
Sources
1
Switcher
2
Projector
3
Connection Guide
1 2
EDID
EDID
EDID
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
EDID
Notes
Rev C June 2016
page 29