Table of Contents
Advertisement
AES Channel Status (All)
For the option "Professional" these values are used:
Format:
Audio Mode:
Emphasis:
Freq. Mode:
Sample Freq.:
Channel Mode:
User Bits:
Auxiliary Bits:
Audio Word
Length:
Important note! If you generate a new AES channel status, the Audio Mode will be automatically set to
Non Audio (AKA "other") for both channels of an adjacent pair (1/2, 3/4 .....) if encode audio is detected
that carries a Dolby E stream for example.
Embedder Audio
Delay
SDI OUT G1 CH1 (ms)
...
SDI OUT G4 CH16 (ms)
Set up GUI – INTERFACES – Dante I/O Interface – Status
The Dante interface connects an EASY LOUDNESS to an audio over IP (AoIP) network. Junger Audio
has committed itself to the quasi industry standard Dante developed by Audinate:
Dante does away with heavy, expensive analog or multicore cabling, replacing it with low-cost, easily-
available CAT5e, CAT6, or fiber optic cable for a simple, lightweight, and economical solution. Dante
integrates media and control for your entire system over a single, standard IP network."
The network infrastructure for Audio over IP must be able to handle the IP multicast. So it needs a bit
of care when it comes to network gear. The recommendation is to separate the control network from
the audio network.
For details pls. refer to the Audinate web-site: https://www.audinate.com. Here you will find many useful
application videos and FAQs.
To configure such an audio network you need the DanteController software. You can download it from
the Audinate website. People who want to interface a PC or MAC to such an audio network can use
the Virtual Soundcard or even more sophisticated the Via, an applications software from Audinate.
The Virtual Soundcard provides audio drivers to connect with common audio tools while Via allows
you to connect network audio resources with PC audio resources like analog line / Mic / USB-Audio /
even applications (Skype, youtube you name it) directly.
We highly recommend reading the Audinate documents to understand how to set-up and operate
a real-time AoIP network.
Looking at the rear panel the RJ45 connector, the primary is the on the left while the second connector
acts either as a redundant or as a switch port. Both RJ45s have built in LEDs. The left one shows
network activities (flashing green) while the right one indicates the interface speed,
with green=1Gbit/s and off=100MBit/s.
[Transparent / Professional]
Professional
[Audio / Non Audio]
None
Locked
48kHz
Not Indicated
None
24Bit
Not indicated
Each embedder signal may be delayed independently. This may be useful
for Lips Sync alignment if a video delay is used.
[0.0000 ... 340.000]
[0.0000 ... 340.000]
"Based on industry standards, Audinate created Dante, an uncompressed,
multi-channel digital media networking technology, with near-zero latency and
synchronization ... One cable does it all.
EASY LOUDNESS
26
Advertisement
Table of Contents
