junger EASY LOUDNESS Manual page 16

This Device
Serial Number
Name
Location
Admin / Contact
Graphical User Interface
Startup Page View
Authentication
Enable
Change Password for
Password
Repeat
Important Note! The authentication may be enabled / disabled from the console interface
(see page 8 "1: Manage Password") via USB connection, but also via Telnet! If you have higher security
demands you should turn the Telnet server off. Authentication will be turned off and passwords will be reset if
one initializes the device to factory default (see Reboot - page 19, INIT/RESET rear button - page 4).
If there was an authentication failure, the admin will be notified
about such conditions at the next proper login. The pop up
appears for each login that has failed. It shows the IP address of
the device that caused the authentication failure.
After a correct login the status "who" (e.g. admin)
and a <Log Out> button are available from the GUI
in the upper right corner:
Network
IP Address
Netmask
Gateway
Transmit Metering Data
Enable
Input fields for information used by higher level services.
The electronic serial number. It is printed on a label at the rear of the
device.
Give the device a meaningful name that may be used by name services
and SNMP management.
The place where the EASY LOUDNESS is located.
E-mail address of a person in charge. Could be used by an SNMP
manager to notify that person.
[Onair max / Preset max, Onair max / Preset min, Onair min / Preset max,
Last Used]
Defines the appearance of the parameter panes in the ON AIR vs.
the PRESETS area (which one will be visible).
To prevent non-authorized people from changing EASY LOUDNESS
settings the administrator may assign passwords for either the admin
and/or an operator. While the admin is allowed to set everything, an
operator is just allowed to load presets. Parameters will be reset if the
operator attempted to change it.
[ON / OFF]
The administrator may turn authentication OFF.
[admin / operator]
Select which password you will set / change.
Type in a password
Default passwords are: admin (for admin) and operator (for operator).
Repeat that password
IP address setup, see above:
getting started – IP setup of the EASY LOUDNESS
A proper address for your network – default [10.110.xxx.yyy]
The net mask of your network – default [2555.255.0.0]
The optional gateway address – default [0.0.0.0]
[OFF / ON]
Metering data will be streamed via UDP protocol. In order not to receive
such data by external applications you may disable it.
12
EASY LOUDNESS
via web browser
–