Getting Started - Snapshot Concept; Getting Started - Quick Start Guide - junger EASY LOUDNESS Manual

Snapshot Concept
The EASY LOUDNESS incorporates a sophisticated snapshot management system.
Snapshots may fire a combination of three presets and can control the measurement.
* Routing Presets for System set up, Interfaces, Routing
* Level Magic Presets
* Measurement Presets to control loudness measurement for the device
These events may be fired by Triggers.
Trigger sources may be GPIs and/or hotkeys of the X*AP RM
information.
Getting Started – quick start guide
Before the EASY LOUDNESS can be used, there are some basic configuration steps which must be followed
in the order set out below. This example assumes you will process one stereo program that is embedded into
SDI group1 Ch1/2.
* Connect the SDI signal (from a source like the station router or video server) to the SDI IN.
* Connect the SDI OUT connector to your destination device (station router or monitor box).
* Hook up the device to the station PC network
- Consult your IT administrator for assistance if you are not sure about this procedure
- Connect it to a switch or hub or directly to a PC / Laptop via an Ethernet cable
(some PCs need a cross over [1:1] cable when connected with the D*AP4 directly)
- Find an unused IP address - ask your administrator!
- Assign it that IP address and set the network mask accordingly, a gateway is optional
(see next page for details)
* Open a browser (FireFox recommended) and connect with the device
- Type in the assigned IP address as an URL: http://<ip-address>
* Check the routing to the Audio Processor (DSP)
- Home > Input Routing > 1L/1R=SDI 1/2
* Check the routing from the Audio Processor (DSP)
- Home > Output Routing > 1L/1R=SDI 1/2
Now you should hear your source stereo program signal at the destination and you may start experimenting
with the various parameters of the AUDIO PROCESSOR blocks.
Important Note! The EASY LOUDNESS is factory default pre-configured for
SDI I/O Group 1 (channels 1/2 and 3/4).
EASY LOUDNESS
remote panel, or the device error status
1
6