junger EASY LOUDNESS Manual page 31

EASY LOUDNESS
Below is the Status page of the DANTE interface board:
Important Note! If this parameter is set to "Dante Network", the EASY LOUDNESS must be synchronized
to the same clock as the network clock master (whoever it is). It must be set to "Dante Network" if this
module is to become the "Preferred Master" of the network.
Sync Status
Preferred Master
Primary Sync Status
Network Audio Sample Rate [44.1 kHz / 48 kHz / 88.2 kHz / 96 kHz]
Device Latency Setting
Dante
Device Name
Primary
Network Status
Secondary
Network Status
Device Access [Unlocked / Locked]
Lock Status
AES67 Mode
Status
Clock Synchronization
Sync Source
[Unlocked / Locked / Locked-Async]
The sync source for the Dante interface is the Dante network.
If no network cable is connected the interface is "Unlocked". If it is
connected to a network it will be "Locked". If the EASY LOUDNESS
is set to synchronize to other than the Dante interface it will show
"Locked-Async".
[No / Yes]
The Dante algorithm automatically looks for the best clock master
inside the network but one may force a Dante module to become
the clock master.
[Slave / Master]
Depending on the A*P device type the sample rate is limited to the
device specification.
[5ms]
You can allow for a certain transmission latency if you face network
problems of any kind.
27
The name you gave the interface
board via the DanteController:
Device > Device View > Device
Config
[Offline / Connected + bandwidth]
[Offline / Connected + bandwidth]
See Dante Controller
[Diasbled / Enabled]
See Dante Controller to enable it.
[Dante Network / DA*P is Master]
Here you define the reference
clock for this Dante module.