Table of Contents
Advertisement
You must use the scroll bar to navigate through the matrix. In the upper left hand corner you can select
between the ON AIR and the PRESETS view of the matrix. On the ON AIR page you will also see the
bluish device signal labels (e.g
Channel Linking
You may select cross points by hovering with the mouse over the little squares and selecting / deselecting
cross points with a left mouse button click.
Mouse over
dark blue
orange
grey
red
.
An animated signal flow
Set up GUI – INTERFACES – SDI I/O interface – Setup
3G SDI Mode
Level B Stream
Select
Test Pattern Generator
Mode
Video Format
DSP
x).
[mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
Color codes of cross points:
Possible new cross point.
You are about to reconnect a cross point.
Cross point is not allowed (i.e. routing will cause a loop and will not
therefore be performed) or dedicated input is not activated.
You are about to disable a cross point.
will help you when navigating through the matrix.
SDI Bypass
SDI Relay Bypass Will deactivate the Bypass
SDI Embedder
Bypass
Video Delay
Video Delay
(frames)
A 3G-SDI signal may have two HD sub streams (e.g. for 3-D TV),
AKN as 3G-B standard. Select between stream 1 or 2 for embedded
audio. See SMPTE 425M for details.
The interface offers a test generator to either check downstream
connections during installation or for use in case of an input fail but you
may also use it to move 16 independent audio channels over a single
coax cable from point to point.
[OFF / AUTO (Input Loss) / Always ON]
[Last valid / one of the defined SD / HD 3G formats (see specs)]
[Color Bars / Black Frame]
24
EASY LOUDNESS
Relay. It provides a shortcut from
SDI-IN to SDI-OUT1 and
disconnects the de-embedder
from the SDI input. This relay
also serves as a fail bypass
if the power is off. This feature
maintains the SDI signal for
downstream equipment.
Will pass the embedded audio
data from the de-embedder to the
embedder 1:1. This function
preserves the original
ancillary data structure.
[0 ... 15]
For compensation of any kind of
audio processing delay within the
chain of devices you may use a
Video Delay. Position "0" turns
off the delay function.
Advertisement
Table of Contents
