Table of Contents
Advertisement
a) Electrical E control
Fig. 71. Hydraulic distributor E – description of distributor functions:
1- turntable, 2- arm extension, 3- 2nd extension arm, 4- main extension arm, 5- cutting part, 6- start
To overload hydraulic distributor with electrical control:
push the button (6) and turn it left,
next adjust hydraulic actuators by pushing buttons (1), (2), (3) on coils under hydraulic
hoses,
to change sections (4) and (5) firstly apply 12V voltage on the coils and then adjust in the
same manner as in the case of other.
b) EP control – electrical-proportional
Fig. 72. Hydraulic distributor EP – description of distributor functions
1- turntable, 2- arm extension, 3- 2nd extension arm, 4- main extension arm, 5- cutting part
2- turntable, 3- 2nd extension arm, 4- main extension arm, 5- cutting part
To adjust hydraulic distributor with electrical-proportional control:
adjust hydraulic actuators by pushing buttons (1), (2), (3) on coils,
to change sections (4) and (5) firstly apply 12V voltage on the coils and then adjust in the
same manner as in the case of other.
CAUTION!
Follow the above procedure only in an emergency, and therefore do not apply
it for normal extension arm operation.
Operator's manual
1
6
distributor
1
2
Camel 900 EP, KWT 650 EP, KWT 651 EP:
KWT 550 EP:
- 57 -
Arm
Flail head
4
5
2
3
4
5
3
Advertisement
Table of Contents
