Power Supply - Digital Projection Insight 4K Laser Series Important Information Manual

Important Information

Power supply

The projector is so designed that it operates with the power supply voltage described
below.
•
AC200–240V 8.2 A 50/60Hz Single-phase
Ensure that your power supply fits this requirement before attempting to use your
projector.
Use only the power cable provided.
Use a power cable that meets the standards and power supply voltage of the country
where you are using the projector. Refer to user's manual for details on connecting the
power cable.
Ensure that the power outlet includes a Ground connection, as this equipment MUST be
earthed.
Handle the power cable carefully. A damaged or frayed power cable can cause electric
shock or fire.
•
Do not bend or tug the power cable excessively.
•
Do not place the power cable under the projector, or any heavy object.
•
Do not cover the power cable with other soft materi- als such as rugs.
•
Do not heat the power cable.
Placing the power cable and the signal cable closely to each other can cause beat
noise. If this happens, keep the two separated so that beat noise is not generated.
Beat noise is corruption of the picture often seen as a rolling band moving through the
image.
Do not touch the projector or the power plug during a thunder storm. Doing so can
cause electrical shock or fire.
When installed on the ceiling, install the breaker in a location that is easy to reach by
hand.
Do not unplug the power cable from the wall outlet or projector when the projector
is powered on. Doing so can damage the projector. Do not unplug in the following
circumstances:
•
While projecting images
•
While cooling after the projector has been turned off. (The POWER button LED
blinks in green while the fan is rotating, and "cooling..." is displayed on the LCD
screen. The cooling fan continues to work for 90 seconds.)
Do not turn of the AC power for 90 seconds after the laser is turned on and while the
POWER indicator is blinking green.
Doing so could cause premature laser failure.
Use of a wall outlet with a 20 A or more circuit breaker is recommended.
Page 14
Digital Projection INSIGHT 4K Laser Series
Rev E October 2016