Connect The Harness Cable To The Boom Function Controls - Raven AutoBoom Installation Manual
Metalfor 2200, 2500, and 3000 series
Hide thumbs
Also See for AutoBoom:
- Installation manual (92 pages) ,
- Calibration & operation manual (50 pages) ,
- Installation manual (73 pages)
Table of Contents
Advertisement
Chapter 5
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-033) into the correct
2.
ports of the AutoBoom node.
Tighten the bolts on the node connectors to secure the connections.
3.
Connect the Harness Cable to the Boom
Function Controls
Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-033).
1.
Route the connectors to the AutoBoom valve (P/N 063-0131-126).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
5.
Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.
6.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
7.
Locate the Left Prop and Right Prop connectors on the harness cable.
8.
Connect the Left Prop connector to Port 5A on the AutoBoom valve.
9.
Connect the Right Prop connector to Port 13A on the AutoBoom valve.
10.
Machine's Boom Function Coils
FIGURE 2.
Locate the boom function coils on the machine's hydraulic valve.
11.
Disconnect the din connector from the machine's left tilt up coil.
12.
Install a boom sensor adapter cable (P/N 115-0230-075) between the coil and the machine's coil connector.
13.
Connect the remaining boom sense adapter cables between the left tilt down, right tilt up, and right tilt down
14.
coils and the coil connectors.
On the harness cable, locate the Left Solenoid Sense connectors.
15.
Isolate the cable labeled Up and connect it to the left tilt up coil via the installed boom sense adapter cable.
16.
Connect the down Left Solenoid Sense connector to the left tilt down coil via the installed boom sense
17.
adapter cable.
Connect the Right Solenoid Sense connectors to the machine's right tilt up and right tilt down coils via the
18.
installed boom sense adapter cables.
22
Metalfor 2200, 2500, and 3000 Series AutoBoom™ Installation Manual
Advertisement
Table of Contents
