Table of Contents
Advertisement
Getting Started
STEP 4. Install the Software
Power Up the Controller
If you are using a remote controller, complete the following steps:
1. Install the cable interface between the remote controller and the chassis. If
2. Power up the chassis.
3. Power up the PC.
If you are using a remote controller and you have installed the interface cable, you must
CAUTION
power up the chassis BEFORE you power up the PC.
When you power down your system, shut down the PC BEFORE you power down the
chassis.
If you are using an embedded controller, complete the following steps:
1. Install the embedded controller module into a compatible chassis. The
2. Connect peripherals (mouse, keyboard, monitor).
3. Power up the chassis.
Software Installation Overview
The software installation includes the following items:
•
Version 17.1 (or newer) of the Keysight IO Libraries Suite is required.
NOTE
•
•
you are using an Keysight M9021A cable interface, refer to the Keysight
M9021A documentation for further details.
Keysight M9018A PXIe chassis is recommended. Refer to the Keysight
M9018A documentation for further details.
Keysight IO Libraries Suite (IOLS), which includes the Keysight Connection
Expert. This software is included with your shipment and the latest version
is available at
www.keysight.com/find/iosuite.
installed first.
Network analyzer module software, which includes the soft front panel
(SFP) software, device drivers (IVI-C and IVI-COM, and LabVIEW G), and
documentation for the M9485A PXIe Vector Network Analyzer modules.
This software is included with your shipment and is also available at
http://www.keysight.com/find/m9485A.
PXIe Chassis Drivers, which includes IVI-C (32-bit/64-bit), IVI-COM
(32-bit/64-bit), MATLAB (32-bit only), LabVIEW (32-bit/64-bit) for M9018A.
This software is pre-installed on the
This software must be
38
Advertisement
Table of Contents
