Keysight Technologies M9485A Startup Manual page 19

Getting Started
STEP 3. Install the Network Analyzer Modules
M9341A (Digital I/O) and M9379A (RF Amplifier) Installation
When connecting or disconnecting a cable to the M9379A module, do not touch the open
WARNING
end of the cable. Doing so may damage the module by electrostatic discharge (ESD).
2-Way Divider and 4-Way Divider Installation
M9485A can work with M9341A Digital I/O and M9379A RF Amplifier. Here
is the limitation of module
M9379A Installation:
• Empty slot is not allowed between source module and last receiver
modules.
• When M9379A is installed between receivers, the sync signal connection
at the front panel between M9379A and M9376A/77A is necessary.
• Refer to Online Help > Programming > I/O Connector (M9845A) >
Example 5 and 6.
M9341A Installation:
• Only one M9341A can be installed in a chassis.
a. Upon placing all the modules into the chassis, if you are using dividers,
fasten the modules only after alignment plate is installed.
page 20 shows the installation of the M9376-60016 4-Way alignment
plate on the modules.
b. Only after the alignment plate is installed, the black plate cover should
be removed. 2-port module have the option of using M9376-60014
2-Way alignment plate.
c. Next, fasten the M9376-62006 4-way divider by ensuring that the
SMP-SMP adapter are fit well through the alignment plate, as shown in
Figure 1-9 on page
M9376-62004 2-way divider.Confirm that the screws on 2/4 way divider
are fasten firmly.
d. In the case of Standard Receivers M9376A only, 4-port modules requires
3 of the 4-way divider to be connected. Similarly, 8-port modules require
6 of the 4-way divider and 12-port modules require 9 of the 4-way
divider.
e. In the case of Configurable Test Set, there are several options of divider
combinations. Refer to
Installation" on page 14
21. 2-port modules have the option of using 3 of the
"Configurable Test Set (M9377A and M9378A/B)
for the full combinations.
19
Figure 1-8 on