Table of Contents
Advertisement
Getting Started
STEP 3. Install the Network Analyzer Modules
b. Hold down the silver locking tab while pushing down the injector/ejector
handle to the unlatched (downward) position, and slide the module to
the rear of the chassis.
c. Slide the module completely into the chassis. When you begin to feel
resistance, pull up on the injector/ejector handle to fully inject the
module into the chassis. The injector/ejector handle should lock into
place. (To remove the module from the chassis, you must first press the
injector/ejector handle to unlock it.)
Figure 1-3
Installing the Network Analyzer Module
7. Repeat for other modules, if present.
8. Modules should be installed from left to right and not otherwise.
9. If the number of receiver is equal or less than 6, up to 6-port module on a
single chassis configuration can be applied. Hence, for up to 6-port
module, Case 1
10.When placing all the modules by the sequence, place the screws at the top
and bottom of each module but keep all the screws loose until all module
are properly placed.
Figure 1-4
or Case 2
Figure 1-5
11
can be applied.
Advertisement
Table of Contents
