Table of Contents
Advertisement
Getting Started
STEP 3. Install the Network Analyzer Modules
There are two M9309As in each configuration. They are not identical. M9309A of M9389A
NOTE
should be installed next to M9310A. M9389A consists of M9309A and M9010A.
Standard Receiver (M9376A) Installation
Figure 1-4
Case 1: Up to 12-port Module in One Chassis Configuration
There are 3 options of receiver installation, standard receiver (M9376A)
installation, direct access receiver (M9377A) installation and configurable
test set (M9377A and M9378A/B) installation. All 3 installations are
explained in the following sections.
Module location for single chassis can be either one from the following two
configuration for single chassis. If each module is not placed in the right
slot, the M9485A software will not be able to control them.
•
Figure 1-4 on page 12
configuration when only standard receiver modules are installed.
•
Figure 1-5 on page 13
receiver modules on a single chassis.
shows up to 12-port module on a single chassis
shows the configuration of 6 or lesser standard
12
Advertisement
Table of Contents
