Power Up The Controller; Software Installation Overview - Keysight Technologies M9451A Startup Manual

Keysight M9451A PXIe Measurement Accelerator

Power up the Controller

If you are using an embedded controller, complete the following steps:

Software Installation Overview

This installation includes the following:
If you are using a remote controller and you have installed the interface
cable, you must power up the chassis
you power down your chassis, Shut Down the PC
the chassis.
PXIe hardware does not support "hot-swap" (changing modules while
power is applied to the chassis) capabilities. Before installing or removing a
module to/from the chassis, power off the chassis to prevent damage to the
module.
Install the embedded controller module into the compatible chassis. The
1.
Keysight M9036A PXIe Embedded Controller and Keysight M9018A PXIe
Chassis are recommended. Please refer to the embedded controller and
chassis documentation for further details.
Connect peripherals (mouse, keyboard, monitor).
2.
Power up the chassis.
3.
Keysight IO Libraries Suite (IOLS), which includes the Keysight Connection
Expert. This software is available at
software must be installed first.
Version 16.3.16603.3 (or newer) of the Keysight IO Libraries Suite is
required.
Instrument software, which includes the soft front panel (SFP), device
drivers (IVI-C and IVI-COM) and documentation for Keysight M9451A PXIe
Measurement Accelerator. This software is included with your shipment and
is also available at www.keysight.com/find/m9451a-driver
BEFORE you power up the PC. When
BEFORE
www.keysight.com/find/iosuite
you power down
. This
.
18