Keysight Technologies M9485A Startup Manual page 39

Getting Started
STEP 4. Install the Software
M9037A Embedded Controller and also available at:
http://www.keysight.com/find/m9018A.
Software Installation Procedure
1. Install the Keysight IO Libraries Suite, using either the Keysight IO Libraries
2. Install the network analyzer module software:
3. If using a remote controller, install the PXIe Chassis Drivers
4. Complete the installation:
Check for software updates at:
NOTE
When you use non-keysight chassis, the setup for trigger routing is required. See the FAQ
NOTE
at:
Suite CD included with your shipment, or the downloadable file at
www.keysight.com/find/iosuite.
IO libraries.
a. Using either the CD included with your shipment or the downloadable
file at http://www.keysight.com/find/m9485A,
b. Follow the installer prompts.
a. Using the downloadable file at
launch the installer.
b. Follow the installer prompts.
If Using an Embedded Controller:
a. After the InstallShield Wizard has completed, click Finish.
b. Restart the embedded controller PC, using Start > Restart, and wait
for the system to restart.
If Using a Remote Controller:
a. After the InstallShield Wizard has completed, click Finish.
b. Shut down the remote controller PC, using Start > Shut down.
c. Power down the chassis.
d. Power up the chassis.
e. Power up the remote controller PC.
http://www.keysight.com/find/m9485A.
Follow the installer prompts to install the
http://www.keysight.com/find/m9018a,
http://www.keysight.com/find/m9485A.
39
launch the installer.