Keysight Technologies M9485A Startup Manual page 35

Getting Started
STEP 3. Install the Network Analyzer Modules
Figure 1-31 Cable Connection of 2 Chassis with Configurable Test Set and Standard
Receiver or Direct Access Receiver (with 2-Way Divider) - 2
11.Figure 1-30 on page 34
Table 1-8 Part Numbers of Required Cables for Connection
No
a
b
c
d
e
f
g
1
2
connection of 2 chassis with configurable test set and either standard or
direct access receivers, with 2-way dividers. There are many options of
configuration and this is one of them. For connection as this, a set of cables
as shown in Table 1-8 on page
Cable Part Numbers Connection 1
1250-4189
8120-5091 M9310A 100MHz In
M9309A 100MHz In
M9485-61619 M9310A RF In
M9485-61625 M9340A A Out 3
M9485-61622 M9310A RF Out
M9485-61624 M9340A A Out 3
M9485-61607 M9300A Out 3
Y9485-61601 M9340A B Out 3
Y9485-61602 M9340A B Out 2
and Figure 1-31 on page 35
35, are required.
Connection 2
M9340A B In
M9340A B In
M9309A 100MHz Out
M9309A 100MHz Out
M9309A RF/LO Out
M9340A A In
M9340A A In
M9340A B In
M9340A B In
Divider LO In
Divider LO In
35
shows cable
Note
is SMB-SMA Adapter.
Fix this adapter before
connecting the cable.
Flexible cable
Flexible cable