Page 3
shock hazards and are familiar with the performance and user safety issues. When no conductive part of the circuit may be safety precautions required to avoid the modules are in use and operation within exposed. possible injury. Read and follow all the specified full temperature range is not Do not connect switching cards directly to installation, operation, and maintenance...
Page 4
When fuses are used in a product, replace with the same type and rating for continued protection against fire hazard. Australian Communication and Media This symbol indicates the instrument is Authority mark to indicate regulatory Chassis connections must only be used as sensitive to electrostatic discharge (ESD).
M9451A module, using the PeertoPeerPort IVI interface. Enhanced self-tests for extended frequency ranges with or without the M9169E Step Attenuator. 89600: Power Spectrum speed improvements. Keysight M9393A PXIe Performance Vector Signal Analyzer...
Support for M9415A Noise Correction in FFT Acquisition Mode. Not supported via IVI. Critical Fixes Defect Description 385288 LO Feedthrough causes IF Overloads when using Noise Corrections 391319 Interaction with M90XA prevents newer M90XA versions from running Keysight M9393A PXIe Performance Vector Signal Analyzer...
353408 89600: error reported when switching between IF Mag & External Trigger in Sequenced Mode 353905 89600: minimum gate length limited to 100 ns in zero span 355118 89600: added VBW limiting in zero span 356920 89600: channel filter was not set correctly for non-power spectrum measurements Keysight M9393A PXIe Performance Vector Signal Analyzer...
Added multi-channel synchronization. See IAgM9393.MultiChannelSync.* Critical Fixes Defect Description 337258 89600: Overlap Percentage error with Gate Trigger and Power Spectrum 339914 Comprehensive alignment failed if initial instrument state is Stepped Spectrum and conversion is image protect Keysight M9393A PXIe Performance Vector Signal Analyzer...
320892 RF Attenuation Change is not proportional to Mixer Level Offset change 338088 Document how to do calibration with 89600 and M9393 hardware 338101 Alert user that no signal should be present on the M9393A during calibration Software Defects Fixed:...
Need help?
Do you have a question about the M9393A and is the answer not in the manual?
Questions and answers