DAHAO BECS-285A Owner's Manual page 31

the frame in the corresponding direction. Press the two neighboring keys at the same
time to move the frame in the direction of the angle bisector. "
key for manual frame-moving. Press "
and (Low Speed).
3. Clear the Frame Coordinates
When the machine stops, click
or click
displayed in the main interface. The function can be used with manual frame-moving.
Manual Color-Changing ：
4.
When the machine stops, click
color-changing interface. Then click the needle number for color-changing, and the
machine head will automatically move to the corresponding needle position.
Please pay attention: if the user wants to automatically save the order of the manual
color-changing (when the "Store Manual Color" in embroidery parameters is set as yes),
user should operate it in the manual color-changing interface
Adjust Main Shaft Manually ：
5.
Usually, the main shaft needs to stop at 100° at needle/color-changing,
frame-moving and beginning embroidery. The user can manually turn the main shaft to
100° when it hasn't reached there. Click
the function.
After the operation, the icon
by (main shaft in the right position).
6. Back to Origin
In the main interface click
the frame will return to the start point.
Owner's Manual of BECS- 285A Computerized Control System
Chapter 2 Embroidery Guide
on main interface directly to clear the XY displacements
(main shaft not in the right position) will be replaced
and choose
" to switch between
and then click "Clear X/Y Displacement"
in the main interface to enter the manual
in the main interface and then carry out
in the followed prompt. Then
" is the speed
(High Speed)
21