DAHAO BECS-285A Owner's Manual page 173

Appendix 5 Automatic Limits Function for Cloth Embroidery/ Cap Embroidery
X Frame Actual Size L
"X Frame Size" and "Y Frame Size" should be set according to the frames actually used.
Attention: because usually the cloth frame is not the rectangle, this parameter value shall be set
according to the available embroidery range of the frame in actual. We can take the picture at
below as the reference:
X/Y Center (X,Y) can be figured out from the calculation and measurement. We take the
"Cloth Frame A" as example. The size of cloth frame A is 550×375, the embroidery area at
430×260. Therefore L=550,W=375.
Set the X/Y Center of the "Cloth Frame A" as 0, and set the X/Y Frame Size as the actual
embroidery area 430/260.
Owner's Manual of BECS- 285A Computerized Control System
Y Frame Actual Size W
163