DAHAO BECS-285A Owner's Manual page 169

Appendix 4 Network Function of Embroidery Machine
3.2 PC and embroidery machine linked by HUB
In this situation straight-through cable is used to link PC or embroidery machine with
HUB.
3.3 Connect the two networks in "2"through router
4 Setting the network parameters of embroidery machine
4.1 MAC address of embroidery machine
Set MAC address of NIC of embroidery machine. Each embroidery machine has its sole
address. The range of this parameter is 000000000000~00FFFFFFFFFF.
4.2 IP address of server
This parameter has to be the IP address of the PC installed with EmbNetServer. This
address can be found in the display window of EmbNetServer.
For the installation and usage of the EmbNetServer, please refer to the disk attached
4.3 Server port No.
This parameter value is the port number used by EmbNetServer. The number can be found
in the display window of EmbNetServer.
4.4 IP address of embroidery machine
Set the IP address of embroidery machine when it's linked with PC. The IP addresses of
embroidery machines can't be repeated. In one sub network, the network numbers of
embroidery machines and PCs have to be the same. And their computer numbers have to be
Owner's Manual of BECS- 285A Computerized Control System 159