DAHAO BECS-285A Owner's Manual page 129

Chapter 11 About JF Sequin Embroidery
Procedure for Setting Sequin-feeding Mode ：
a) Press number key to confirm embroidery needle position. The needle position
equipping sequin device will display "Sequin Mode";
b) Use
stands for front motor delivery; B stands for middle motor delivery and C stands
for rear motor delivery. AC stands for front/rear motor overlap sequin, AB stands
for front/middle motor overlap sequin, BC stands for middle/rear motor overlap
sequin and ABC stands for front/middle/rear motor overlap sequin;
Note: if there are only two motors, B will stand for rear motor.
c) Press
sequin for feeding (Range: 0~9999). If it requires same mode before
color-changing, then type in "1" and press
d) Use
to confirm and save the settings. Clicking
before the edition.
For example: a machine with needle No. 9 as its end needle (tri-sequin at 3, 5, 7mm); first
needle is single sequin (9mm). The requirement is 7mm at first, then 3 & 5mm overlap, then 5
and 7mm alternate embroidery, then sew 9 pieces of 3mm, 8 pieces of 5mm, 4 pieces of 7mm,
Owner's Manual of BECS- 285A Computerized Control System
or to modify the delivery mode and press
to make sure the sequin-feeding method. Then input the number of
or until you see "END" in "Sequin mode", then press
to confirm. A
.
is to keep the sequin mode
119