Error Code In The Software - XYZ Printing PartPro150 xP Operation Manual

Version 1.0
PartPro150 xP Operation Manual
2002 Laser module not calibrated
2003 Resin bottle ID tag voided
2004 Covers opened
2005 Invalid resin tag detected
2006 File parsing failed
2007 File size over the limit (200MB)
Non-manifold issue found on the
2008
model

Error code in the software

Error Code
1021 Slicer not found
Transmission failure due to
1022
connection issue
Insufficient RAM for loading more
1023
files
1024 System error detected
Unable to save the file to the
1025
selected disk
1026 Non-manifold issue found in the file
of the cartridge.
If the ID tag is missing, please contact the service center
for help.
Contact the service center for help.
The ID tag is void when the resin bottle is empty. Please
replace the resin cartridge.
Close the covers securely.
Install XYZprinting resin bottle and try again.
Parsing failure is caused by slicing issue or incompatible
firmware version. Re-slice the file with the slicing
software. Make sure to specify the corresponding printer
model while exporting the file.
In some case you may need to re-slice the files after
updating the software and the firmware.
Select another file that is smaller than 200MB.
Repair the file with 3D model repairing software (such as
net fabb or Make Printable) and slice the model again.
Cause
Reinstall the software and try again.
Check the USB cable connection between the printer and
the computer and try again. Do not unplug the USB cable
from either side before the transmission is completed.
Try either method below:
 Reduce the size of the model.
 Add more RAM to your system.
Restart the software and try again.
Check the following items:
 Check the connection between the selected disk and
 Check if there is sufficient disk space on the selected
Repair the file with 3D model repairing software (such as
net fabb or Make Printable) and slice the model with the
software again.
54
Troubleshooting
your PC.
disk.