Post-Processing; Cleaning Up The Models From The Platform - XYZ Printing PartPro150 xP Operation Manual

Version 1.0
PartPro150 xP Operation Manual

5. POST-PROCESSING

CLEANING UP THE MODELS FROM THE PLATFORM

Wear protective gloves while cleaning up the platform and the printed models.
1. The printer screen displays below
message when the printing is
completed. Tap [CONFIRM].
3. Scrape off the printed models on
the platform.
Always remove the platform before removing the resin tank to avoid dripping leftover material on printer
surface.
2. Release the bolt handle over the platform and pull out the platform. Recess
resin may drip from the platform. It is advised to hold a tray or absorbent
cloth under the platform while removing it.
4. Go back to the printer screen and
tap [CONFIRM] to end the
procedure.
50
5. Complete the hardware
installation explained on P.6
before the next print.