XYZ Printing PartPro150 xP Operation Manual page 49

Version 1.0
PartPro150 xP Operation Manual
4. Adjust the contact area of the cone support if necessary.
To adjust the contact area of the cone support, go back to the function menu "Support" > "Cone", and select
the button "Contact Area".
Click on the targeted cone (selected cone will change to blue) and drag the slider to adjust the contact area.
Click "Done" once you have adjusted the contact area of all cones.
 Cone support is only available when the overhang is at least 6mm above the platform. The software will
lift the object when necessary.
 The diameter of the support is fixed once added. To adjust the support, please delete the mark, change
the diameters and add the cone mark again.
43