XYZ Printing PartPro150 xP Operation Manual page 11

Version 1.0
PartPro150 xP Operation Manual
7. Move up the platform rack by tapping the following options on the screen:
8. Complete the hardware installations. Tap [>] on the screen after installing each item.
Refer to p.6 to p.8 for detailed instructions on the installation.
•Install the platform.
•Install the wiper.
9. Set up Wi-Fi connection or tap [Not now] to skip the
set up.
•Install the resin tank.
• Install the resin bottle.
•
•
10. Tap [v] to complete the initial setting.
5
Error message 2009 will show
up during the setup, since the
tank is not yet installed.
Simply tap [PROCEED] to close
the message at this stage.