Komatsu WA800-1 Operation & Maintenance Manual page 158

HANDLING OF BATTERY
* If the battery capacity of the
After the engine has started,
normal machine is smaller than the booster cables should be dis-
the battery capacity of the failed connected in the reverse order in
machine,
use two normal which they were connected.
machines. Connect the booster
1. Disconnecting the booster cables
cable from one machine to the I) Disconnect the clip of booster
battery on the right side of the cable B from the engine block
failed machine; connect the which was started.
booster cable from the other ma- 2) Disconnect the other clip from
chine to the battery on the left the negative (-1 terminal of
side of the failed machine using the running engine.
A
the same procedure.
When connecting the cables,
never contact the positive (+I
A
and negative (-1 terminals.
Make sure that the booster
cable connections are correct.
Connect the booster cable to
the engine block as far as possi-
ble from the battery.
3. Starting engine
1) Turn the starting switch to
START position and start up
the engine.
Batterv for enaine which was started
2) If the engine doesn't start at
first, try again after 2 minutes
or so.
(l&&J @ (2) -
Engine block which was started
3)
4)
Disconnect the clip of booster
cable A from the positive (+I
terminal of the running engine.
Disconnect the other clip from
the positive (+I terminal of
the engine which was started.
- 28 -
ww -02053