Komatsu WA800-1 Operation & Maintenance Manual page 110

WHEN REQUIRED
If small holes or thinner parts are
found on element when it is
checked with an electric bulb
after cleaning and drying, replace
the element.
Do not use element whose folds
or gasket or seal are damaged.
When cleaning element, do not
hit it or beat it against something.
c. CHECK AND REFILL
TRANSMISSION OIL
Carry out this procedure if there
is any sign of oil on the transmission
case, or if there is oil mixed with the
cooling water.
1. Use sight gauge (G) to check the
oil level.
2. If the oil level is not between the
top and bottom marks on the
sight gauge, add engine oil
through oil filler (F).
* The type of lubricant used
depends on the ambient tempera-
ture. Select according to the
table "FUEL, COOLANT AND
LUBRICANTS".
- IlO-
* Stop the engine when checking
the oil level.
* Make an oil level check before
starting engine or 60 minutes or
more after the engine is stopped.
If oil remains at various portions,
the correct oil level cannot be
measured.
A
When checking the oil level,
apply the parking brake, and
lock the front and rear frames
with the safety bar and pin.
W-04320