Komatsu WA800-1 Operation & Maintenance Manual page 113

WHEN REQUIRED
g. REPLACING BUCKET TEETH
If the bucket equipped with tip
tooth.
Replace the teeth before they
wear down as far as the adaptor.
3. Steering column (1 point)
If the play of the steering column
is heavy or does not return properly,
0
apply grease.
1. Extract pin (2) fitted to the
bucket and then remove tooth
(I).
* When extracting pin (21, strike
the part (either the left or right
part) with a sharp object. This
will enable the pin to be extracted
from the opposite side.
2. Insert the new tooth (I) into the
adaptor (31, and insert pin (2)
partway as shown in the diagram.
Then drive it home by means of a
hammer.
W-04323
- 113-