Komatsu WA800-1 Operation & Maintenance Manual page 144

BUCKET OPERATION
6. If there is too much material
l
loaded in the bucket, dump and
tilt the bucket quickly to remove
the excessive load.
This prevents spillage of the load
during hauling.
*
1.
When digging and loading on
level ground, set the bucket edge
facing down slightly as follows
and drive the machine forward.
Always be careful not to load the
bucket on one side and cause an
unbalanced load.
This operation should be carried
out in 1 St gear.
Set the edge of the bucket facing
slightly down.
2. Drive the machine forward and
operate the lift arm control lever
forward to cut a thin layer of the
surface each time when excavat-
ing the soil.
3. Operate the lift arm control lever
slightly up and down to reduce
the resistance when driving the
machine forward.
W-03820