Section 2 System: Introduction; How To Use This Manual; Equipment Identification - ESAB CUTMASTER 60i Operating Manual

2.01

How To Use This Manual

This Owner's Manual applies to just product(s) listed on page i.
To ensure safe operation, read the entire manual, including the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and NOTE may appear. Pay particular attention to the
information provided under these headings. These special annotations are easily recognized as follows:
Additional copies of this manual may be purchased by contacting ESAB at the address and phone number in your area
listed on back cover of this manual. Include the Operating Manual number and equipment identification numbers.
Electronic copies of this manual can also be downloaded at no charge in Acrobat PDF format by going to the ESAB
web site listed below and clicking on "Product Support" / "ESAB Documentation": / "Download Library", then
navigate to "Plasma Equipment" and then "Manual".
http://www.esab.com
2.02

Equipment Identification

The unit's identification number (specification or part number), model, and serial number usually appear on a data
tag attached to the bottom. Equipment which does not have a data tag such as torch and cable assemblies are iden-
tified only by the specification or part number printed on loosely attached card or the shipping container. Record
these numbers on the bottom of page i for future reference.
Manual 0-5488
SECTION 2 SYSTEM:
INTRODUCTION
NOTE!
An operation, procedure, or background
information which requires additional
emphasis or is helpful in efficient operation
of the system.
CAUTION
!
A procedure which, if not properly followed,
may cause damage to the equipment.
WARNING
!
A procedure which, if not properly fol-
lowed, may cause injury to the operator or
others in the operating area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings will be
enclosed in a box such as this.
INTRODUCTION
ESAB CUTMASTER 60i
2-1