Table of Contents
Advertisement
INSTALLATION
※ For safety issue, we strongly advise to have 2 technicians work together to install.
1. Unscrew screws ① , and move the Band Feeding Detector ② outward. (move with caution, do not damage the
wire of the detector)
2. Install Band Feeder System ④ onto the table, matching to the position ⑤ .
③
②
3. Apply screws to join the Band
Feeder System ④ and Band
Feeding Detector ② .
4. Connect all plugs and make sure
they are secured.
5. Check the height of the Auto Kit
Before connecting the power and air, press the band clamper to avoid bumping into other parts ① .
Push the feeding plate ② toward the sewing machine until the surface ③ is the even with the needle plate ④ .
When ③ is lower than ④ (more than 0.3mm), or ③ is higher than ④ (more than 0.5mm), loosen the screw ⑤ ,
and adjust screw ⑥ for the proper height.
P2
①
⑤
②
④
④
①
Advertisement
Table of Contents
