Testing Mode - Siruba ASP-EBJ100 Instruction Book

TESTING MODE

②
③
A. To complete one work cycle.
To make sure all the movement timing and the devices´ positions.
1. Press and hold CYCLE STOP ① , and turn on the power at the same time.
2. Check if the indicator POWER ② and STOP ③ are blinking together.
3. Press CYCLE STOP ① . The machine should stop at the very beginning position.
4. Press START ④ to go step by step. The machine will complete the circling and get to the ready for sewing
position.
5. Check the band circling, press CYCLE STOP ① to deliver the band into the sewing area.
Press RESET ⑤ to abort the operation.
6. Press START ④ to complete the sewing step by step. Machine goes back to ready position when it completes.
To continue the operation, go back to step 3.
B. Sewing Machine runs solely.
Machine stops while only the sewing machine runs alone.
1. Press START ④ and turn on the power at the same time.
2. Check if the POWER ② is blinking.
3. Feed in the band manually to the presser foot for trial sewing.
4. Press RESET ⑤ to lower the presser foot. Press RESET ⑤ again to lift up the presser foot.
5. Press START ④ to start operation.
P16
重疊量
LAPPING
SIZE
④ ① ⑤