Setting The Band - Siruba ASP-EBJ100 Instruction Book

SETTING THE BAND

It is necessary to adjust for the 1st work or when working with bands with different width or thickness.
1. To adjust induce plate sensing
range:
When the band goes through
the wall ① and the induce plate
② , you may need to change
the limit switch sensing distance
accordingly by adjusting the
distance between the inducing
plate ② and the limit switch ③ .
Loosen the screws on the limit
switch ④ , move the limit switch
to adjust the limit switch active
range. ( about 2 times of the
band thickness)
2. To adjust the rail:
Loosen the 2 knobs ⑦ , the
distance should be good enough
for the band to go through
( 1mm wider than the band
width). Tighten the knobs ⑦
when finish.
3. To adjust the ready for sewing
position
The edge of the band ⑤ should
align with the push pin ⑧ .
Loosen the screw ⑨ and adjust
the push pin to the edge of the
band. Tighten screw ⑨ .
4. If you find the band curling,
adjust the direction of air blower
⑩ until the band ⑤ is flat and
even.
④
⑤
⑥
⑨
①
②
⑦
⑩
③
⑧
⑤
P7